A properly installed interior perimeter drain system intercepts groundwater at the slab edge and routes it to a sump basin before it ever reaches your floor.

Drain tile that isn't sloped correctly is one of the most common installation failures we see when repairing someone else's prior work — water simply pools instead of flowing to the basin. We verify slope with a level, not by eye.
Every technician is trained specifically on interior drain tile layout, slope, and tie-in to the sump system.
Most Lansing, MI inspection requests get a response within a day or two.
Sump basin and pump costs are itemized separately so you can see exactly what makes up the total.
Drain tile that isn't sloped correctly simply won't move water — we verify slope with a level during installation, not just by eye.

Every Lansing, MI Interior Drainage System job starts with an inspection, not a generic package — here's what that typically includes.
We route the full perimeter or targeted sections depending on where moisture is actually entering, based on the inspection.
Basin placement is chosen for the shortest, most direct discharge path away from the foundation.
For finished basements where cutting the slab isn't practical, a baseboard channel system captures wall seepage without disturbing existing flooring.
The cove joint where wall meets floor is sealed and tied directly into the drain system so water is captured right at the entry point.
We camera-inspect old systems where accessible to determine whether repair or replacement makes more financial sense.

Tell us where water shows up and under what conditions — heavy rain, snowmelt, or constantly — so we can scope the likely system needed.
We also check existing drainage, if any, to determine whether repair or new installation makes more sense.
You'll see drain tile footage, basin specs, and any cove joint work broken out in the written estimate.
We test the system with water flow before finishing to confirm proper slope and basin performance.

"Old drain tile from the 1970s had completely silted up. They cleaned what could be saved and replaced the rest."
— Lansing Homeowner
"Cove joint had been the source of our leak for years and nobody had addressed it until now."
— Lansing Customer
"Explained the slope requirements in a way that actually made sense, not just technical jargon."
— Lansing Homeowner
"Clean install, patched concrete matched the existing floor color almost perfectly."
— Lansing Customer
Not always — if water is only entering along one wall, a targeted section can be enough, which we determine from inspection findings.
We'll recommend whichever fits your basement's finish level and budget.
{Sometimes — if the pipe itself is intact but clogged with silt, cleaning can restore function without a full re-installation.|We camera-inspect where accessible to make that determination before recommending replacement.}
An undersized basin cycles the pump too often, so we don't cut corners on sizing.
If disruption is a major concern, we can discuss the baseboard channel alternative instead.
We give you a realistic timeline in the written quote based on your specific basement layout.
We install and repair interior drainage systems throughout Lansing and the surrounding Lansing, MI service area, including the zip codes listed below.



Zip codes we serve in Lansing, MI: 48933 48915 48912 48911 48910 48906 48901 48909 48916 48919 48922 48924 48929 48930 48937 48951 48956 48917
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.